Hello all!!

My steering is really tight.. added fluid and it is still a little tight.. any suggestions?

Looking for a lid for the incounter ice bucket for my 2000 356. Any ideas????

Need to replace a Sherwood E35 raw water pump on my '77 Mariner on a 270 engine. I can find the pump, but can't find the fittings that connect the pump to the hoses. Any suggestions?

This may be a silly question, but I'd like a second opinion before I go purchasing the wrong tool. I'll be changing both Tides shaft seal kits (the whole assembly) during our upcoming haulout and am getting parts and tools gathered now. They are original to the boat (2002) and are in poor condition overall.



Based on the attached drawings, it looks like the nut (Item 7) that holds the coupler on the shaft is a 2 1/4" nut, but I just want to make sure I'm reading it correctly. If you look at all ...

I need a NAV light switch for my old 1991 26 command bridge. West Marine was a no go. Did google picture search....close....but no. Really don't want to have to change both female end to match a diff swith if ya know what I mean.... Anyone have a connection?

Nolt sure where to put this, but here it is...the fridge in my 1991 Carver 26 command bridge I just bought isn't getting cold. Has power. Freon? Replace? Anyone? Bueler....LOL

Thanks for any and all info you can give me

John

Hi my name is Billy. And I'm a boataholic. Just got a 1998 carver voyager 530 that was pretty neglected. Going to try and bring her back to her former glory. So I started changing batteries and what I thought was fairly easy however there is four marine batteries center forward and I got confused on what goes where. If anyone has a picture or diagram it would be greatly appreciated. I didn't get any books

Billy

There are 2 8ds rear center by generator

There are 2 8ds behind each motor tamd122b' ...

ON the 2005 46MY there must be limber holes below each engine for drainage to the center bilge pump. MY question is where are they?

I have not been able to get the synchronization to turn on. Also cannot turn on one lever operation mode.

When I tried the procedure from the manual, a steady beep started and did not quit until I shifted into neutral and pressed the transfer button.

Much later I noticed errors on both trans controllers. Both had to do with no assignment of a master/slave.

Could this be a transmission setup issue, say function A0 not properly set?

Or is it as simple as not starting the master engine first?



The tra ...

Does anyone have a link to the manual for a 1991 Carver 26 Command bridge? I can't find it online anywhere.

Thanks

John