So I may not using the search option correctly, but im sure somewhere on here is a tutorial on how to change the belt on a 1976 Ford 351M engine.

Hi everyone - new member and first time posting. Our offer was accepted and we are scheduled for survey/haul-out in a couple of weeks on a 2002 396.



However, based on our initial walk-through we identified the swim platform was quite spongy over a large area - especially in the middle section. I have searched and read dozens of posts on here about this issue and the potential causes (e.g. dock box screws, poor davit/aftermarket equipment installs, etc.) so I have a good idea of what SHOU ...

Hi We are Annette and Eddie , boating out of Penetanguishene Ontario on our 96 Carver 325.... Bonnie Berdine.
email 4sailrguyeddy@gmail.com
Picking up very valuable information from other boaters here.
Good site

CARVER 42 FOOT MARINER HIT SAND WITH PROPS. NOW PORT SIDE RUNNING ROUGH OVER 2200 RPM. NO PHYSICAL DAMAGE TO PROP THAT I CAN SEE. IS IT POSSIBLE PROP TWISTED OUT OF BALANCE FROM HITTING SAND? ENGINE NEVER STALLED. PUT IN NEUTRAL ASAP. NO DINGS IN PROP.

42 MARINER 2004. VOLVO GAS ENGINES LOOKING TO PURCHASE 2 PROPS. ANYONE KNOW WHERE I CAN??

After 900 miles the transom is very dirty with soot. We rinsed it every night but it seems as if it is embedded in the gel coat. Tried simple green and a few other hull cleaners and no luck. Any one find a friendly chemical that will work. Thanks in advance for any ideas.

Wondering if anyone knows of a source for 20L x 4 1/2W Teak Boarding steps, we have a few beyond re-teaking, all I can find so far is 15". Thanks for any input.

Good afternoon. Looking for information on trucking our 38SS. Besides arch and windscreen. What else needs to come off? Any advice or shared experience would be appreciated. Thanks in advance.

Hello from Alaska!
Can anyone please help with the info on the 1994 carver 430 prop size? We cannot find the info in our owner manual. We need to replace the starboard side. Also if anyone knows the shaft size that would be super helpful.
Much appreciated!
Tom

My 88 carver 3607 comes with 4 batteries. One for engine starting one for generator starting and two large 4D house batteries. One is reading 13 volts the other 9. I have the switch in the closet to go from battery one to two to all. My norcold fridge works on shore power but very recently will not turn on from house batteries. The light is green and faint and pulses slightly which means it’s getting some power not enough to get cold

I have switched back and forth between batteries and set ...