I purchased a 1987 3207 that has a generator issue. It is a Kohler 7.5R27 (106276-A), serial #177842.

The generator starts and runs for 30 seconds then shuts down. If I disconnect the ground lead from the magneto the engine will run 1 minute then shut down.

I am a pretty good mechanic but don’t know anything about troubleshooting generators.



I would truly appreciate help with troubleshooting, or if anyone has a service/troubleshooting manual, or if anyone knows a good Kohler repair person in the Sa ...

Wanted to share the photos and how to eliminate the engine coolant from going through the water heater. My water heater on my Voyager 370 started leaking water and I was not comfortable having the engine coolant go ing through the water heater so I looped the connections on the engine with a piece of 5/8" silicone heater hose that is rated at 350 degrees and high pressure, yes the hose is better than you need but worth the extra 10 bucks.



Left the hoses going to the water heater in case we hook ...

Hi all,
Im looking at a 1995 Carver 250 mid cabin express. 5.7 mercruiser with a Bravo111. Hull is good. Current owner bought new boat and is looking to sell for $2500. Needs a good cleaning and TLC. Its a Long Island boat.
What do you all think please?

Hi just purchased a 355 aft cabin, our first boat. Would love some suggestions as to what kind of TV to put in the main room (parlor???), pardon my newbie ignorance. Was wondering if anyone has done a projection tv? where? where did you put the screen?

Open to all ideas. Previous owner removed all TV's and a lot of other stuff before we picked it up.

would love to see photos.

Thank you.

Recently purchased our first boat, a 1996 355 Aft Cabin. We are trying to winterize our boat. A handyman can't figure out to winterize the icemaker. Should there be a water cutoff inside?

We don't want to shut off all water because we will be living on board. This new USED boat thing can be a little overwhelming.

Thank you.

LOOKING FOR A CARVER DECK BOX FOR A 1999 356

The wife and I have 2006 Carver 36MY with 8.1L VolvoPenta Gas motors. We're are the 3rd owners and currently moored in Elliot Bay Marina.



During our first dive hull maintenance by J&J diving, after scrubbing the boat and some of the Zincs they noted we had prop damage. J&J pulled props and sent to "the Prop Shop" in Mukilteo WA who trued and straightened them. I then called to ask "what are they?" as I could not find a definitive answer as to what was or should be installed on the b ...

Took my 370 out for a two hour cruise and when we came back the fresh water tanks were empty. Thought it might be the T & P valve so I replaced that but when I hooked the water back up the water heater was leaking a lot from the bottom, it was like a small river so turned off the fresdh water pump and bypassed the water heater so now we only have cold water.



Have been trying to figure out how the water heater can come out of the engine room area. The widest section is the middle but that is ...

Anybody have this done recently? Cost? I'm going to have it done next year.

The Kohler generator I have is a 7.4 KW 1800 RPM unit that generally runs but is ailing and most parts are NLA.

I have been eyeing used westerbeke units and most I can find are only 5kw, which is probably fine but also are 3600rpm.

How much louder will a 3600 be vs an 1800? Will the "exhaust tone" be that much more annoying vs the low rumble of an 1800 RPM unit?