GAS engine, transmission and generator repair and maintenance discussion forum.
0 Replies
146909 Views
Last post by CYO Admin
February 6th, 2013, 7:49 am
360 Replies
1421328 Views
Last post by waybomb
April 26th, 2026, 8:14 am
3 Replies
2462 Views
Last post by Viper
September 3rd, 2018, 9:50 pm
Sporadic Alarm on take off 326 AFT
Replies: 23
by
Marty »
July 19th, 2018, 8:38 am
2000 326 Aft that periodically an alarm sounds when I throttle up to get up on plane. When I back off to idle speed the alarm stops but I have to...
23 Replies
6444 Views
Last post by DCharles
September 2nd, 2018, 10:25 am
Engine Issues
Replies: 4
by
Serendipity »
August 16th, 2018, 7:45 am
Well unfortunately I started the trip yesterday and the starboard engine would not increase above 3000 rpms. Generator started making a clanking...
4 Replies
1700 Views
Last post by Serendipity
August 29th, 2018, 10:27 pm
Crusader 5.7 TBI Specs
Replies: 2
by
Zarko48 »
August 27th, 2018, 10:56 am
Hi All
2 Replies
2280 Views
Last post by Zarko48
August 27th, 2018, 6:28 pm
Spare Parts while on a LONG passage
Replies: 14
by
Kendaukcat »
August 16th, 2018, 11:06 am
Good Morning!
14 Replies
4576 Views
Last post by Keith S
August 24th, 2018, 1:19 pm
Velvet Transmission sensor bypass
Replies: 3
by
flo2 »
August 18th, 2018, 10:54 am
I was having fun down there in the engine room(closet) and pulled a wire connected to a sensor on the transmission.
3 Replies
1833 Views
Last post by flo2
August 19th, 2018, 9:30 am
Fuel Maintenance Strategy
Replies: 9
by
steveoh »
August 17th, 2018, 8:48 am
My last boat was a diesel boat, and as I continue my search for a 325/326 Aft cabin gas boat, something occurred to me. Based on an experience having...
9 Replies
3184 Views
Last post by 390Express
August 18th, 2018, 9:22 pm
10 Replies
5546 Views
Last post by tomschauer
August 17th, 2018, 2:00 pm
When Was Fuel Injection Introduced?
Replies: 5
by
steveoh »
August 9th, 2018, 3:24 pm
Anybody have an idea in what model year fuel injection was introduced in the Crusader engines? Also, I read something that said the CM 350XL was...
5 Replies
4235 Views
Last post by 390Express
August 17th, 2018, 12:22 am
Hatch gasket?
Replies: 2
by
390Express »
July 6th, 2018, 5:00 pm
My boat has a large hatch that opens with two hydraulic rams, and a smaller hatch in the large hatch for quick access, and in case I need access with...
2 Replies
1551 Views
Last post by 390Express
August 16th, 2018, 6:23 pm
3207 Ignition Problems
Replies: 4
by
redmen62 »
August 13th, 2018, 9:20 pm
Hey everyone,
4 Replies
1891 Views
Last post by km1125
August 14th, 2018, 11:20 am
5 Replies
3218 Views
Last post by Keith S
August 9th, 2018, 12:54 pm
Hurth 630 Transmission
Replies: 3
by
staticman4414 »
July 29th, 2018, 10:39 pm
So I have Crusader 5.7L engine, and a Hurth 630 transmission , but the engines are mounted "backwards" So the flywheel is towards the front-Bow of...
3 Replies
1851 Views
Last post by Bandit
August 6th, 2018, 10:10 am
Water in the tranny
Replies: 13
by
denpooch »
July 21st, 2018, 10:20 am
Unfortunately the unthinkable happened!
13 Replies
4728 Views
Last post by denpooch
July 23rd, 2018, 8:13 pm
Fuel shut off in 1997 Carver 325 Aft
Replies: 7
by
nazinteck »
June 11th, 2018, 2:53 pm
I recently purchased a 1997 CARVER 325 Aft Cabin with twin GAS TB350 XLi engines. I am looking to inspect and replace (as needed) engine tune-up...
7 Replies
2561 Views
Last post by nazinteck
July 23rd, 2018, 12:30 pm
Gas fume detector
Replies: 4
by
Mindy »
July 16th, 2018, 10:04 pm
Hi Everyone! We bought a 1986 Carver 4207 in May. We had a faulty Gas Fume detector & gauge. My husband has ordered another one to replace it. He...
4 Replies
1856 Views
Last post by Mindy
July 17th, 2018, 9:29 pm
12 Replies
4264 Views
Last post by bud37
July 17th, 2018, 9:22 am
Rudder water leak
Replies: 5
by
pepmyster »
July 16th, 2018, 8:22 am
Hi guys! I noticed water around the shaft of the starboard rudder shaft. Port side is dry as a bone. Anyone have this happen? 360 Sport Sedan....
5 Replies
2315 Views
Last post by pepmyster
July 16th, 2018, 8:35 pm
Transmission Fluid Pump
Replies: 12
by
crquisto »
July 10th, 2018, 1:04 am
I’m pretty sure my port transmission is not pumping fluid as it should. This is a 2000 406 with 7.4 MPIs and Velvet Drive Model 30-01-005 trannies...
12 Replies
3973 Views
Last post by Keith S
July 12th, 2018, 3:05 pm
Noise above 2600 rpm
Replies: 5
by
crquisto »
July 27th, 2017, 2:47 pm
I have a rubbing or weird grinding noise from my port side when in gear with rpm above 2600. It sounds almost like wood on metal. I hit a log pretty...
5 Replies
2071 Views
Last post by crquisto
July 12th, 2018, 10:52 am
Looking for part on exhaust system
Replies: 6
by
Cooler »
June 19th, 2018, 10:49 am
Hello All! I have a 1995 Crusader 350XL engine. The first fiberglas exhaust connector, with the built in back flow flapper, developed a crack and is...
6 Replies
2688 Views
Last post by Cooler
July 11th, 2018, 9:03 am
Gas usage math formula?
Replies: 4
by
RickieT »
July 8th, 2018, 2:00 pm
Greetings Fellow Carver Owners...
4 Replies
1854 Views
Last post by RickieT
July 9th, 2018, 4:29 pm
48 Replies
24270 Views
Last post by 390Express
July 9th, 2018, 11:48 am
Help!
Replies: 7
by
Grafunkus »
June 27th, 2018, 8:21 pm
So it turns out that our starboard engine requires a new transmission. We have a 1982 Carver Mariner 3396 with two Crusader 350 engines. The ballpark...
7 Replies
3128 Views
Last post by 390Express
July 6th, 2018, 4:54 pm
oil pressure dropped, now wont start
Replies: 25
by
cpoint »
June 10th, 2018, 11:11 pm
2018-06-10_22-53-31.png Hi All,
25 Replies
6672 Views
Last post by bud37
July 2nd, 2018, 4:48 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum
Sponsors