Hello All,



I own a 1997 325 Aft Cabin. Had a problem with my port side losing power under load. Wasn't fuel or fuel venting. Voltmeter showed low on port side. Had to run across the Chesapeake on 1 engine to save power for docking.



I've got it narrowed down to electrical. Odd thing is that I'm not showing my alternators charging but I'd like to see a wiring diagram. My "Captains Kit" that came with the boat does not go into detail with electrical schematics and Carver's site does not contain the m ...

To our US carvonians, enjoy your day......Happy 4th of July........

We have 2 350 engines Crusaders should we be using a synthetic oil?

I have a 1993 350 aft cabin and the sliding door has a crack right in the center that runs about half way up. The just taped it up any ideas on either a more permanent repair for a replacement? It's about half inch plexiglass.

Can I just replace the rubber cap or do I need to replace the entire switch?

Hi, names Phil, just got a 19900 Carver Californian 45 foot with Cat diesels. I was told that on some of these models the rear fuel tank can rust underneath. Does anyone know of this problem or a way to check for leaks before pumping in diesel fuel ??
Any help will be appreciated. Thanks. ps, LOVE the boat !!

Anyone with a 350 mariner installed a holding tank vent filter, I am thinking I may have to do this, just a little concerned about pump out restriction and the best place to install this thing.I know you can make them,almost bought the stuff, but I like the bypass feature in the big orange one ( pricey though), and don't know if that will fit in a Mariner.....fire away guys....

The decorative foam backed vinyl wall covering in the bedroom on my Mariner 350 is comming loose. What do you recommend I use to stick it back down?

I have a 1997 Carver 355 aft cabin...aux 30 gal fuel tank hasnt been used in couple of years...does fuel go bad and if so, should I drain or add additive? Thanks, safe boating this holiday weekend!

79 voyager 3326 port engines exhaust got very hot and had to be shut down. It wasn't pumping sea water (freshwater cooled engine). Began trouble shooting at the sea strainer, closed the sea cock and opened the strainer and it is clean. Opened the sea cock (with the strainer still open) expecting water to at least bubble out of the strainer and none did. Is this normal? Shouldn't water run out do the strainer when the strainer is open and the sea cock is open?