Does anyone know where i can get a wiring schematic for a 2000 396? Thanks

I own a great 3207 that has been in my family since 86. My only concern is my flybridge steering is leaking hydraulic fluid from the front of the console. I undid the bolts, thinking I needed to find a bleed valve. Since this, it leaks. Is there a gasket or should I just make my own?

On my 1995 325 AFT the hard panels on the outside of the rails are missing. This is the railing on the deck just above the aft berth. It appears they were cut off as I can see grinder marks on the railing where some of the mounting holes are. My wife wants hard side skirting vs. canvas. I'm going to DIY this but have them custom cut. Does anyone know what material I should use? Where can I find the stand offs Anyone done this before or have some tips? Thanks in advance.

Have a 506 2002. Anyone know where to get the cabinet knobs. All my info says they have been discontinued , Thank you.

I have a 1997 325 Aft Cabin with 350 Crusaders. The manual says there are anti-syphon valves in the fuel system, and recommends inspecting/cleaning them. The book does not show you where they are located or what they look like. Can anybody give me this information? Thanks

Hello, Sitting here on my 466 and all the monitors started beeping. I believe the signal is for low power. How does one ascertain if power fell? Thanks

Just purchased a 1988 Carver Mariner 3697. Ice maker not receiving water (entire system was winterized) and pressurized water system not functioning. I found the manual online with a general water diagram, but can't find the 3 tank diagram. Can someone help me locate the diagram and figure out how to get water to the ice maker? (This is my first boat!)

I am new with Carvers and still learning many things. The Volvo Diesels on board are TAMD74P. Just a basic question... what is the difference between a TAMD74L or TAMD74/C? Looks like size and shape and maintenance requirements are the same but I guess I'm just bothered that I don't know the difference. Is it worth knowing the difference? Thanks again. Jerry Nicholas