1994 390 CPMY with 454’s. How do you know when to replace the exhaust hose? Mine is still pliable, but a lot of cracks on the outer part of the hose....
I know the debate is probably older than I am, but it’s pertinent to me, cause now I’m talking about my boat. I’ve got two raw water cooled Crusaders...
While Removing the Aft cabin Carpet the other day i noticed on the Port side bed platform that it was wet near the bottom. not exactly sure why so i...
New to me 2003 356. What is the First Mate system? I have a switch under the step at the battery switch panel labeled First Mate which is off since I...
Question for a newbie with a 3807,
In north Alabama water temp would rarely if ever get below freezing, except maybe a little thin surface ice during...
On the aft enclosed deck of my 444 there are 2 drain scuppers. (they maybe there on a 396 also) They are in the rear of the deck, one in each corner....
As part of the renaming ceremony for our new boat we have to remove the painted name on the stern. I’ve seen a video using EZ OFF oven cleaner. What...
Carver 325 -Should I have zincs on my propeller shafts? what is the shaft size 1.5 inch? I do have a transom zinc. Any advice is appreciated. I have...
I have been getting fuel smells in my boat, and replacing fuel fill hoses and vent hoses. In the process I found my fuel sender/floats are leaking on...
Had a question...I have a 350 Mariner and need to replace my transient dock lines for bow & stern...so 4 are needed. General consensus for length is...
I have a 1983 Aft Cabin 3607 and have been wondering about a wood square on the port side of my hull (pictured). The wood is rotting apart but since...
Hi Guys,
We just purchased a 1988 3807 and are getting to know this boat. During the sea trials, the surveyor marked the volt meters at the upper and...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
Sponsors